Akademik Veri Yönetim Sistemi
Journal of Advanced Oral Research, cilt.15, sa.2, ss.124-130, 2024 (ESCI)
Aim: This study set out to determine the tensile bond strength between denture bases (produced by 3D printing technology, conventional technique, and computer-aided design and computer-aided manufacturing [CAD/CAM] milled) and silicone-based soft lining material. The consequence of thermocycling on the bonding strength was also investigated. Materials and Methods: The bonding between denture foundation materials produced through three distinct techniques (conventional, CAD/CAM milled, and 3D printed) and silicone-based soft lining material was examined. Before tensile testing, half of the samples underwent thermocycling (5–55°C, 5,000 cycles) in 37°C distilled water for 48 hours. A universal testing apparatus employed a crosshead speed of 5 mm/min. The failure type was identified visually, and the maximum tensile strength was noted. The Shapiro-Wilk test and analysis of variances (P =.05) were used to assess the statistics. Results: CAD/CAM milled denture base material (1.56 ± 0.62/1.36 ± 0.16 MPa) showed higher bond strength values than the other denture bases in the tensile test conducted before and after thermocycling (P <.001). The denture base material made conventionally had the lowest bond strength (1.02 ± 0.24/0.77 ± 0.1 MPa) (P <.001). The tensile bond strength values of the conventional and 3D printing groups showed a statistically significant drop before and after thermocycling (P =.001). Regardless of thermocycling, adhesive failure was primarily seen in all groups (76.6%). Conclusion: Compared to conventionally produced denture bases, the bond strength of soft relining materials to CAD/CAM milled and 3D printed denture base is different. In denture base materials that are conventionally, CAD/CAM and 3D printed, the thermocycling method reduced bonding strength values.